GT SLOTS

 

CLOVERLEAF (MI.) RACER RESIN REGIONAL 2010 

 

DATE/TIME (all times Eastern):  Saturday February 20, 2010.  Racing to start after conclusion of NSR Regional being held same day and location. 
 
TRACK LOCATION and CONTACT: 
 
Cloverleaf Raceway
7746 Clyde Road
Fenton MI 48430
Contact Phone: 248-931-3930
 
Steve Olgilvie built track in Fenton, Michigan.  The track is a  5 lane track 120+ foot lap length Steve Oglivie built track.  Click here for  pictures.

ENTRY FEE:  $20 (if also entering Cloverleaf NSR Regional, $30 for both races)

ELIGIBLE CARS:

Any Racer Resin brand car, kit or RTR, is allowed.  Kits must be complete with all the parts that come in the kit.  As new cars are introduced they will become eligible.  Click this link for example cars:

THE BODY:

Bodies must not be modified or cut in any way, exception being thinning the resin for tire clearance.   Kit cars must have numbers showing on front and sides of the body.  Cars must start each race with all parts intact except for mirrors, wipers and antennas.   All cars must start with rear wing in place, if it comes on original model. Bodies can be painted.  Bodies must be attached to chassis using provided screws in stock location. If body screws are run loose, tape must be placed over holes in bottom of chassis. Car must have interior, Slot.IT lexan interiors are allowed.  Windows must remain transparent.

CHASSIS:

Racer chassis only w/Slot-it motor pods.  NO TRACTION MAGNETS.   Inline & sidewinder motor pods only, standard or offset.  Sanding edges of motor pods and chassis for float is legal.
No modifications to axle mounts front or rear is permitted.  Front axle ride height
adjusting blocks must be in place.  The complete interior must be used and no modification or lightening is allowed.  Axle shims and/or stoppers are allowed.

WHEELS AND TIRES:

Racer or Slot.IT wheels must be used.  Slot.IT F1 wheels not allowed.  The correct inserts for the wheel must be used.  Any Slot.IT silicone tire (except F1) Indy Grip P/N 3003 tires allowed on rear.  Slot.IT Zero grips or stock Racer tires can be used on the front.  Rear tires may extend past body by no more than 1mm.  Original inserts must be used but may be painted.  No chemicals may be used on the tires.

GUIDE BLADES:

Any Slot-it or Racer guide blades are allowed.

Any manufacture braid and wire can be used-must be attached to guide through
Slot-it eyelets and may not be glued or soldered.

MOTOR:

Only Slot-it "Orange endbell" motor is legal (21,500 rpm @ 12volts)
Any Slot-it pinion may be used.  Motor to be supplied by GTSLOTS and returned after the race.

GEARING:

Any gear ratio is allowed using Slot-it gears

WEIGHT:

Weight may be added to the inside of the chassisl  NO weight may be attached to the underside of the chassis.

LIGHTING:

May be added. (Optional) If used must be Slot-it brand.